Park Zone PZ-1900 Platinum Dual Power Garage Parking Aid

Park Zone PZ-1900 Platinum Dual Power Garage Parking Aid

The Park Zone Platinum Dual Power Garage Parking Aid guides you into the correct parking area by sensing the precise distance from your garage wall to the car’s bumper with the aid of ultrasonic sensing device. It features a sleek, high-tech design with sophisticated circuitry that looks and acts like a space age traffic light. This parking aid includes a star IV energy saving AC adapter, and is backed by a one-year warranty against defect in materials and workmanship.

Product Features

  • Allows Precision Parking Every time
  • Easy to Install
  • Simple to understand traffic light design
  • Auto on/off senses vehicle movement
  • Runs with AC adaptor included or on 4 AA batteries (required)

2 thoughts on “Park Zone PZ-1900 Platinum Dual Power Garage Parking Aid

  1. Andrew Jordan "LongLiveChuck"
    Andrew Jordan "LongLiveChuck" says:

    Good but… This is a good product, but the reason I bought it is because there is not much space between the wall and the front of my car (about 3 inches so that the garage can close) and I needed a guide so that I didn’t hit the wall. What this product description doesn’t tell you is that the minimum distance that the sensor has to be from the car is 1 foot 4 inches and if I had that much room to play with then I wouldn’t need a parking guide in the first place. Other than that it is a good product that is easy to set up and easy to use.

  2. MI Feller

    An all-round excellent product Installation took less than 30 minutes. Mounted the two sections (sensor and indicator light) to the wall in front of car. Connected these with the snap-in cord provided. This is necessary because the sensor is placed at bumper height, while the indicator light mounts a few feet above. Next, I plugged the indicator light into a nearby AC outlet, set the car in position, and switched the unit on. Blinking lights confirmed that the unit was recording the location of the car. However, due to the slight “reflex time” it takes to actually stop after seeing red, I decided to re-set the unit with the car back a bit farther. Re-setting is easily accomplished by switching the unit off and than on again. Device has been in operation for several weeks now and has worked flawlessly. Its bright colored lights are easy to see under various conditions. Helpful hint: Mounting screws are included but I did not notice a “template”. You can make one easily by placing a piece of paper against the back of each unit and punching holes to match those on the back. Use this to assist in drilling holes for the screws.

Leave a Reply